IGC 2000 Description

The IGC 2000 integrates all the power plant control functions into a single micro-processor based controller. Pre-engineered and pre-programmed, the IGC 2000 is a standardized, off-the-shelf power plant controller.The controller is programmed at the factory and comes with a floppy disk that turns any IBM PC or compatible into an operating terminal for the power plant or the configuring system for the IGC 2000. User-friendly software guides the power plant owner or his start-up engineer through a configuring process that, when completed, tailors the standard IGC 2000 Francis turbine controller to a specific power plant. The configuration process can take as little as two or three hours. If you don't get it exactly right the first time or if you need to make changes at some later date, the system is easily re-configured.

IGC International Limited
P.O. Box 1474
Woodinville WA 98072
Phone: 425-486-2043
EMAIL: igc@igcinternational.com

Copyright © IGC International, Inc. 1996-2006 All rights reserved. IGC 2000 is a trademark of IGC International, Inc.

• Completely user configurable
  
• Electronic governing
  
• Automatic synchronizing
  
• Eight selectable automatic power control modes
  
• Two override control cycles
  
• Four selectable reactive power control modes
  
• One-line metering and dat display on VDT
  
• Annunciator display
  
• Auto restart on return of line power
  
• Direct connection to CT's and PT's
  
• Isolated operation
  
• Shutdown on configurable alarms
  
• Lockout on configurable alarms
  
• Manual controls
  
• Incomplete sequence alarm
  
• Net head calculation
  

• Remote control
• SCADA interface
• Alarm, status,and command logging timed to 1/60 second
• Data logging at user selectable interval and sequence of events recording
• Line protection Overfrequency
  Underfrequency
  Overvoltage
  Undervoltage
  Voltage unbalance
• Generator protection Overvoltage
  Overcurrent
  Reverse power
  Current unbalance
  Loss of excitation
  Differential
  Neutral overvoltage
• Temperature protection, stator and bearings
• Direct RTD input

   

  The IGC 2000 includes manual control panels that bypass the microprocessor.This manual capability eases the start-up process, facilitates maintenance and provides a last ditch method of operating the plant.
  The IGC 2000 not only replaces many separate components normally used in the power plant, it improves on those components. For example, synchronizing with the IGC 2000 is much more accurate, quicker and smoother than with a separate governor and synchronizer.
  The IGC 2000 replaces power plant black boxes with tested and field proven firmware which is extremely reliable.